Fanuc Starting System Software Please Wait |work| File

Troubleshooting the “FANUC Starting System Software Please Wait” Message

Green LEDs: On many R-30iB controllers, there should be four LEDs; typically, the top two should be lit and the bottom two should be blinking. Any other pattern suggests a hardware fault on the main board or its components. 3. Use the Boot Monitor (BMON) for Recovery fanuc starting system software please wait

This guide applies to FANUC CNC controls (Series 0i, 30i/31i/32i, Power Motion i, and RoboDrill). For FANUC 0i-D / 30i series : Power on while holding ``

Key insight: This is not an "alarm" per se. Alarms (ex: SV001, PS0000) appear after the software loads. This message indicates the control cannot finish loading its own operating system. there should be four LEDs

Step 2 – Boot with “Depressed Keys” (Reset to IPL mode)

• For FANUC 0i-D / 30i series: Power on while holding ``.(decimal) and-(minus) keys, orRESET + DELETE` on the MDI panel.
• This enters IPL (Initial Program Load) mode. From here:

  If you're encountering the "FANUC Starting System Software Please Wait" message on your FANUC control system, it typically indicates that the system is initializing or attempting to load the necessary software components. This message can appear during the startup process of FANUC CNC systems or other machines equipped with FANUC controls. Here are some insights and steps you can take to troubleshoot or understand the situation better: