Xerox Fault Code 043-343 !new! 🔥 📌

Troubleshooting Xerox Fault Code 043-343: A Guide to the YMC Link Sensor Fail

: A mismatch of print mode and YMC link sensor driven state register information. Primary Causes Faulty or misaligned YMC link sensor Damaged or worn drive assembly gears Xerox Fault Code 043-343

• The error can reappear intermittently if only paper is cleared without cleaning rollers.
• No clear on-screen hint about which roller is slipping – requires experience.

. Essentially, there is a mismatch between what the printer’s mode should be and the actual state reported by the link sensor. This is commonly seen on Xerox VersaLink Troubleshooting Xerox Fault Code 043-343: A Guide to

4. Root Causes

Field service analysis identifies three primary causes for Fault Code 043-343: The error can reappear intermittently if only paper

Step 1: Perform a Full Power Cycle (The "Hard Reboot")

Do not simply press the power button. A true hardware reset can sometimes clear transient errors.

Check the interior of the printer for any scraps of paper, dust buildup, or toner spills near the sensor area that might be blocking the YMC Link Sensor's line of sight. 4. Hardware Inspection (Advanced)

Sensor and Solenoid Check: Technicians use the dC330 diagnostic mode (code 042-011) to initialize the First Bias Transfer Roller (1st BTR) and observe if the link bar moves. Hardware Inspection: